Skip to main content
ElectraCore
LearnCalculatorsCircuit DesignerReferences
Saved
Educational use: ElectraCore supports learning and preliminary checks. It does not replace a competent electrician or engineer. Verify results, equipment data, and current local regulations before installation or live work.
Courses/Inspection & Testing/Continuity Testing

exercise · 6min · Lesson 10 of 36

Continuity exercise

Complete the exercise before marking this lesson complete.

Course syllabusCourse overview
01Test Sequence & Preparation
  1. ReadWhy test sequence matters: safety
  2. ReadDead tests before live tests
  3. ReadTest instrument calibration and leads
  4. ReadBS 7671 Appendix 6 test schedule
  5. quizPreparation quiz
02Continuity Testing
  1. ReadRing final continuity: three tests explained
  2. ReadProtective conductor continuity
  3. ReadMain and supplementary bonding continuity
  4. ReadContinuity test results: limits and recording
  5. exerciseContinuity exercise
03Insulation Resistance
  1. ReadIR testing principles: 500V, 1000V
  2. ReadTesting between live conductors and earth
  3. ReadLow IR readings: causes and diagnosis
  4. ReadElectronic equipment and IR testing
  5. quizIR testing quiz
04Earth Fault Loop Impedance
  1. ReadExternal impedance Ze measurement
  2. ReadTotal loop impedance Zs measurement
  3. ReadComparing Zs to Table 41.1 limits
  4. ReadCorrecting excessive Zs readings
  5. exerciseZs measurement exercise
05RCD Testing
  1. ReadRCD tripping current tests: half-rated and rated
  2. ReadRCD trip time testing at 1× and 5× rated current
  3. ReadMaximum trip time limits for different RCD types
  4. ReadRecording RCD test results
  5. quizRCD testing quiz
06Polarity & PFC
  1. ReadPolarity testing: dead and live methods
  2. ReadPFC measurement at origin and boards
  3. ReadVerifying PFC against device ratings
  4. quizPolarity and PFC quiz
07Certification & EICRs
  1. ReadEIC: Electrical Installation Certificate
  2. ReadMinor Works Certificate: when to use
  3. ReadEICR: periodic inspection
  4. ReadObservation codes C1, C2, C3, FI
  5. exerciseEICR coding exercise
08Final Assessment
  1. exerciseFull mock test schedule: complete it
  2. quizFinal written assessment
Exercise · 6min
Problem

A ring final has r1=0.80 Ω, rn=0.82 Ω and r2=1.32 Ω. L-N cross-connected readings cluster around 0.405 Ω. L-CPC readings rise from about 0.53 Ω toward 0.66 Ω near the midpoint then fall. One outlet reads open circuit on L-CPC. Interpret the evidence.

Personal study record

Lesson notes

Ready

Notes are stored on this device unless you export them.