Skip to main content
ElectraCore
LearnCalculatorsCircuit DesignerReferences
Saved
Educational use: ElectraCore supports learning and preliminary checks. It does not replace a competent electrician or engineer. Verify results, equipment data, and current local regulations before installation or live work.
Courses/Industrial Control & PLCs/PLC Fundamentals

exercise · 15min · Lesson 25 of 30

Writing a simple motor control program

Complete the exercise before marking this lesson complete.

Course syllabusCourse overview
01Motor Starters
  1. ReadDOL starter: main and control circuit
  2. ReadStar-delta starter: wiring and timer
  3. ReadSoft starters: operation and parameters
  4. ReadVariable speed drives: inverter drives
  5. quizMotor starter quiz
02Contactors & Overloads
  1. ReadContactor construction and ratings
  2. ReadAuxiliary contacts and interlocking
  3. ReadThermal overload relays: setting the dial
  4. ReadElectronic overloads and motor protection relays
  5. exerciseContactor circuit problems
03Control Circuit Diagrams
  1. ReadIEC 60617 symbols: reading control diagrams
  2. ReadLadder diagrams: European and American styles
  3. ReadDrawing a full DOL control circuit
  4. ReadForward-reverse motor control
  5. exerciseDiagram reading exercises
04Safety Systems
  1. ReadEmergency stop requirements: IEC 60204
  2. ReadSafety relays and safety PLCs
  3. ReadLight curtains and safety interlocks
  4. ReadSafe isolation: EAWR and multi-energy control
  5. quizSafety systems quiz
05PLC Fundamentals
  1. ReadWhat is a PLC and where is it used?
  2. ReadPLC architecture: CPU, I/O modules, power
  3. ReadLadder logic basics: contacts and coils
  4. ReadTimers and counters in ladder logic
  5. exerciseWriting a simple motor control program
06Panel Layout & Installation
  1. ReadPanel design: layout and component spacing
  2. ReadCable management inside panels
  3. ReadLabelling, ferrules, and documentation
  4. ReadPanel testing and commissioning checklist
  5. quizFinal assessment
Exercise · 15min
Problem

Design scan-based logic for a motor with momentary START, healthy STOP/overload permissive, seal-in, no automatic restart after power recovery, and a 3 s delayed auxiliary fan. Safety stopping remains hardwired/safety-rated outside this basic PLC logic.

Personal study record

Lesson notes

Ready

Notes are stored on this device unless you export them.